Outside corner U24X light grey To cover and protect cables in corners. Grey. Insulating material. Easy mounting: The external piece hides the cut marks of both trunking and cover. The internal piece allows for an easy measuring of the cover and retains the cables. Protection against mechanical damage IK08.
Inside corner, U24X, light gray To cover and protect cables in corners. Grey. Insulating material. Easy mounting: The external piece hides the cut marks of both trunking and cover. The internal piece allows for an easy measuring of the cover and retains the cables. Protection against mechanical damage IK08.
Flat angle U24X light grey To cover and protect cables in corners. Grey. Insulating material. Easy mounting: The external piece hides the cut marks of both trunking and cover. The internal piece allows for an easy measuring of the cover and retains the cables. Protection against mechanical damage IK08.
Clamp, U23X For safe and easy cable routing in the duct. Ensures that the cover is held firmly in place even in difficult places: impact-resistant, for use on standpipes, overhanging mounts, outdoors, etc. One clip is supplied per 0.5 m of trunking for fixing to the side walls. Additional clamps can be added to the duct run if required. Quick installation by pressing on the duct side walls, even with partitions attached to the duct bottom.
Joint cover U24X For covering trunking top joints. Color: light gray RAL 7035. Insulating material. Easy mounting. Protection against external mechanical stress. Degree of protection IK08.
Partition wall, U23X For the separation of electric circuits. Delivery length: 3m. Color: gray. Insulating material. Easy assembly. Protection against external mechanical stress. Degree of protection IK08.
Clamp, U24X For restraining cables and wires. The installation channel is supplied with 1 clamp per 0.5m. Insulating material. Easy mounting. Protection against external mechanical stress. Degree of protection IK08.
Butt joint connector U24X Two butt joint connectors pre-assembled at one end of the trunking are supplied. They are used to mechanically connect two trunking sections, ensure their perfect alignment and thus facilitate the assembly and fastening of the trunking base. Frontal mounting by pressure. Fits all duct sections and allows combination of sections of different lengths. The connector aligns the cover and the duct floor section against each other. For suspended, wall and ceiling mounting.
End piece U24X To cover ends in trunking installations. 2 screws included. Insulating material. Easy mounting. Protection against mechanical damage IK08.
Connecting /branching box U24X To cover cables and protect connections in branchings. Insulating material. Easy mounting. Protection against mechanical damage IK08.
Edge strip flat angle U24X To keep the right bending radius in telecommunications installations. Grey. Insulating material. Easy mounting. Protection against mechanical damage IK08.
Installation trunking 3m U23X grey For distribution. Suitable for outdoor use. Complete range with all necessary fittings, available in white and grey. Homogeneity with the rest of the installation's elements. 1 cable retainer every 0,5m is included. Length: 3m. Grey. Safety: electrical (insulating material, IP4X mounted on wall); mechanical (protection against impacts IK08); and in front of fire (glow-wire test at 960°C; non-flame propagator). Easy mounting. The cover is pressure mounted (no need to slide it). The cable retainer retains the cables and allows for independent access to each circuit. Homogeneity of colours between the trunking and the fittings. Can be painted. Removable divider, pressure mounted.